A manufacturer-documented scope for Whirlpool front-load washer error codes. Individual model matches should be added as manuals are resolved.
Use only when the appliance is a Whirlpool front-load washer and the displayed code is covered by the cited Product Help article.
Keep this scope separate from Whirlpool top-load HE washers. Front-load F8 E1/LO FL is documented as low water flow; the page also includes front-load-only codes such as F5 E2, F7 E1, F8 E2 and F9 E1.
The Whirlpool front-load code article confirms user-accessible checks for water supply, inlet hose kinks, detergent/dispenser issues and drain hose conditions depending on the displayed code. A model-specific owner manual is still required for full maintenance intervals.
No Whirlpool front-load recall has been attached to this scope in the launch corpus. Recall pages should remain separate and matched by exact model or official affected-product range.
For Whirlpool front-load washers, F8 E1 or LO FL is documented as a low-flow water-supply condition; the same row documents the Pause/Cancel twice and Power once clearing step.
For Whirlpool front-load washers, F5 E2 is documented as the door not locking properly, with checks for blocked or incomplete door closure and a Pause/Cancel twice plus Power once clearing step.
For Whirlpool front-load washers, F7 E1 is documented as a motor speed sensing error tied to cycle speed, shipping bolts and overload checks, plus a Pause/Cancel twice and Power once clearing step.
For Whirlpool front-load washers, Sud or Sd is documented as excess suds; the article also connects this condition with HE detergent use and possible drain hose or standpipe restrictions.
For Whirlpool front-load washers, F8 E2 is documented as a dispenser-system problem on select models, with the detergent drawer or cartridge checked for detergent clogging.
For Whirlpool front-load washers, F9 E1 is documented as drain times longer than expected, typically over eight minutes, with drain hose and standpipe checks.
For Whirlpool front-load washers, rL or F34 is documented when items are detected in the washer during the Clean Washer cycle; the listed action is to remove items and restart that cycle.
For Whirlpool front-load washers, LOC or LC is documented as Control Lock being activated, with Whirlpool directing users to the Control Lock button or the owner manual on older models.
For Whirlpool front-load washers, dET is documented as detergent cartridge not detected in the dispenser on select models; Whirlpool says to ignore it when using single-load doses.
For Whirlpool front-load washers, Int is documented as the cycle being paused or canceled, with Pause/Cancel twice plus Power once and a five-minute power disconnect if still displayed.
For Whirlpool front-load washers, LO FL is listed with F8 E1 in the official error-code article as the low-flow/fill code group.